ar71xx: Remove TX/RX delay from pll_1000 for OM5P-AN

The tx/rx delay bits in the ETH_XMII_CONTROL register have to be unset when the
enable_rgmii_rx_delay/enable_rgmii_tx_delay will be set in the AT803x PHY.
Othwise the throughput in gigabit mode is heavily reduced.

Signed-off-by: Sven Eckelmann <sven@open-mesh.org>
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@45521 3c298f89-4303-0410-b956-a3cf2f4a3e73

diff --git a/target/linux/ar71xx/files/arch/mips/ath79/mach-om5p.c b/target/linux/ar71xx/files/arch/mips/ath79/mach-om5p.c
index 272e410..298e80c 100644 (file)
--- a/target/linux/ar71xx/files/arch/mips/ath79/mach-om5p.c
+++ b/target/linux/ar71xx/files/arch/mips/ath79/mach-om5p.c
@@ -202,7 +202,7 @@ static void __init om5p_an_setup(void)
        ath79_eth0_data.phy_if_mode = PHY_INTERFACE_MODE_RGMII;
        ath79_eth0_data.mii_bus_dev = &ath79_mdio0_device.dev;
        ath79_eth0_data.phy_mask = BIT(7);
-       ath79_eth0_pll_data.pll_1000 = 0x1a000000;
+       ath79_eth0_pll_data.pll_1000 = 0x02000000;
        ath79_eth0_pll_data.pll_100 = 0x00000101;
        ath79_eth0_pll_data.pll_10 = 0x00001313;
        ath79_register_eth(0);