ramips: mt7620: fix failsafe switch config

As indicated in the bug tracker[1], failsafe mode is broken on at least some
devices using the mt7620 switch (and possibly mt7621). The thread explicitly
mentions the Xiaomi MiWifi, and the Nexx WT3020, and an unspecified device
using the mt7621 switch; the issue also applies to the Netgear EX2700.

The problem is that failsafe mode uses eth0, but enable_vlan is always set to 1
by the switch driver. Connecting to and/or pinging the device fails. This patch
fixes the failsafe preinit config, by making sure that vlan support is disabled.
It currently only fixes the switch config on mt7620, but might apply to the
mt7621 as well, so the patch has been designed with this in mind.

A similar (line wrapped) patch was submitted in December by Simon Peter, but never
accepted and/or discussed.

This patch applies to both Chaos Calmer and trunk.

[1] https://dev.openwrt.org/ticket/18768

Signed-off-by: Joseph C. Lehner <joseph.c.lehner@gmail.com>
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@48772 3c298f89-4303-0410-b956-a3cf2f4a3e73

diff --git a/target/linux/ramips/base-files/lib/preinit/07_set_preinit_iface_ramips b/target/linux/ramips/base-files/lib/preinit/07_set_preinit_iface_ramips
index 3dce1b6..6948851 100644 (file)
--- a/target/linux/ramips/base-files/lib/preinit/07_set_preinit_iface_ramips
+++ b/target/linux/ramips/base-files/lib/preinit/07_set_preinit_iface_ramips
@@ -7,8 +7,22 @@
 
 ramips_set_preinit_iface() {
        RT3X5X=`cat /proc/cpuinfo | egrep "(RT3.5|RT5350|MT7628|MT7688)"`
+       MT762X=`cat /proc/cpuinfo | egrep "MT7620"`
+
        if [ -n "${RT3X5X}" ]; then
                swconfig dev rt305x set reset 1
+       elif [ -n "${MT762X}" ]; then
+               # The mt7530 switch driver enables VLAN by default, but
+               # failsafe uses eth0, making the device unreachable:
+               # https://dev.openwrt.org/ticket/18768
+               case "${MT762X}" in
+               *MT7620*)
+                       mt762x_switchdev=mt7620
+                       ;;
+               esac
+               swconfig dev $mt762x_switchdev set reset 1
+               swconfig dev $mt762x_switchdev set enable_vlan 0
+               swconfig dev $mt762x_switchdev set apply 1
        fi
 
        if echo $RT3X5X | egrep -q "(RT5350|MT7628|MT7688)"; then