enable_atheros() {
local device="$1"
+ # Can only set the country code to one setting for the entire system. The last country code is the one that will be applied.
+ config_get country "$device" country
+ [ -z "$country" ] && country="0"
+ local cc="0"
+ [ -e /proc/sys/dev/$device/countrycode ] && cc="$(cat /proc/sys/dev/$device/countrycode)"
+ if [ ! "$cc" = "$country" ] ; then
+ rmmod ath_pci
+ insmod ath_pci countrycode=$country
+ fi
config_get channel "$device" channel
config_get vifs "$device" vifs
ifconfig "$ifname" up
- # TXPower settings only work if device is up already
- config_get txpwr "$vif" txpower
- [ -n "$txpwr" ] && iwconfig "$ifname" txpower "${txpwr%%.*}"
-
local net_cfg bridge
net_cfg="$(find_net_config "$vif")"
[ -z "$net_cfg" ] || {
[ -n "$ssid" ] && iwconfig "$ifname" essid on
iwconfig "$ifname" essid "$ssid"
set_wifi_up "$vif" "$ifname"
+
+ # TXPower settings only work if device is up already
+ config_get txpwr "$vif" txpower
+ [ -n "$txpwr" ] && iwconfig "$ifname" txpower "${txpwr%%.*}"
+
case "$mode" in
ap)
config_get_bool isolate "$vif" isolate 0