Clean up the prom code / board detection (thanks Gabor), fix some warnings

[openwrt.git] / target / linux / rb532 / files / arch / mips / rb500 / devices.c

diff --git a/target/linux/rb532/files/arch/mips/rb500/devices.c b/target/linux/rb532/files/arch/mips/rb500/devices.c
index 1ca808b..d2476a8 100644 (file)
--- a/target/linux/rb532/files/arch/mips/rb500/devices.c
+++ b/target/linux/rb532/files/arch/mips/rb500/devices.c
@@ -23,6 +23,8 @@
 #include <linux/mtd/mtd.h>
 #include <linux/mtd/partitions.h>
 
+#include <asm/bootinfo.h>
+
 #include <asm/rc32434/rc32434.h>
 #include <asm/rc32434/dma.h>
 #include <asm/rc32434/dma_v.h>
@@ -230,10 +232,14 @@ static void __init parse_mac_addr(char *macstr)
 
 static void __init rb500_nand_setup(void)
 {
-       if (!strcmp(board_type, "500r5"))
+       switch (mips_machtype) {
+       case MACH_MIKROTIK_RB532A:
                changeLatchU5(LO_FOFF | LO_CEX, LO_ULED | LO_ALE | LO_CLE | LO_WPX);
-        else
+               break;
+       default:
                changeLatchU5(LO_WPX | LO_FOFF | LO_CEX, LO_ULED | LO_ALE | LO_CLE);
+               break;
+       }
 
        /* Setup NAND specific settings */
        rb500_nand_data.chip.nr_chips = 1;
@@ -258,7 +264,7 @@ static int __init plat_setup_devices(void)
        /* Read the NAND resources from the device controller */
        nand_slot0_res[0].start = readl(CFG_DC_DEV2 + CFG_DC_DEVBASE);
        nand_slot0_res[0].end = nand_slot0_res[0].start + 0x1000;
-       
+
        /* Initialise the NAND device */
        rb500_nand_setup();