ralink: add mt7621 support

[openwrt.git] / target / linux / ramips / rt3883 / config-3.10

diff --git a/target/linux/ramips/rt3883/config-3.10 b/target/linux/ramips/rt3883/config-3.10
index e99d3ac..911d703 100644 (file)
--- a/target/linux/ramips/rt3883/config-3.10
+++ b/target/linux/ramips/rt3883/config-3.10
@@ -2,7 +2,6 @@ CONFIG_AR8216_PHY=y
 CONFIG_ARCH_BINFMT_ELF_RANDOMIZE_PIE=y
 CONFIG_ARCH_DISCARD_MEMBLOCK=y
 CONFIG_ARCH_HAS_ATOMIC64_DEC_IF_POSITIVE=y
-CONFIG_ARCH_HAS_RESET_CONTROLLER=y
 CONFIG_ARCH_HAVE_CUSTOM_GPIO_H=y
 CONFIG_ARCH_HIBERNATION_POSSIBLE=y
 CONFIG_ARCH_REQUIRE_GPIOLIB=y
@@ -28,6 +27,7 @@ CONFIG_CPU_R4K_FPU=y
 CONFIG_CPU_SUPPORTS_32BIT_KERNEL=y
 CONFIG_CPU_SUPPORTS_HIGHMEM=y
 CONFIG_CSRC_R4K=y
+CONFIG_DEBUG_PINCTRL=y
 CONFIG_DMA_NONCOHERENT=y
 # CONFIG_DTB_RT3883_EVAL is not set
 CONFIG_DTB_RT_NONE=y
@@ -100,6 +100,7 @@ CONFIG_MTD_M25P80=y
 CONFIG_MTD_OF_PARTS=y
 CONFIG_MTD_PHYSMAP=y
 CONFIG_MTD_PHYSMAP_OF=y
+CONFIG_MTD_SPLIT_FIRMWARE=y
 CONFIG_MTD_UIMAGE_SPLIT=y
 CONFIG_NEED_DMA_MAP_STATE=y
 CONFIG_NEED_PER_CPU_KM=y
@@ -125,6 +126,11 @@ CONFIG_PCI=y
 CONFIG_PCI_DOMAINS=y
 CONFIG_PERF_USE_VMALLOC=y
 CONFIG_PHYLIB=y
+# CONFIG_PINCONF is not set
+CONFIG_PINCTRL=y
+CONFIG_PINCTRL_RT2880=y
+# CONFIG_PINCTRL_SINGLE is not set
+CONFIG_PINMUX=y
 # CONFIG_PREEMPT_RCU is not set
 CONFIG_RALINK=y
 CONFIG_RALINK_USBPHY=y
@@ -144,12 +150,13 @@ CONFIG_SERIAL_OF_PLATFORM=y
 # CONFIG_SLAB is not set
 CONFIG_SLUB=y
 # CONFIG_SOC_MT7620 is not set
+# CONFIG_SOC_MT7621 is not set
 # CONFIG_SOC_RT288X is not set
 # CONFIG_SOC_RT305X is not set
 CONFIG_SOC_RT3883=y
 CONFIG_SPI=y
 CONFIG_SPI_MASTER=y
-CONFIG_SPI_RALINK=y
+CONFIG_SPI_RT2880=y
 CONFIG_SWCONFIG=y
 CONFIG_SYS_HAS_CPU_MIPS32_R1=y
 CONFIG_SYS_HAS_CPU_MIPS32_R2=y