ramips: add additional uarts to mt7628.dtsi

[openwrt.git] / target / linux / ramips / dts / WHR-300HP2.dts

diff --git a/target/linux/ramips/dts/WHR-300HP2.dts b/target/linux/ramips/dts/WHR-300HP2.dts
index 28917fe..b3b3a87 100644 (file)
--- a/target/linux/ramips/dts/WHR-300HP2.dts
+++ b/target/linux/ramips/dts/WHR-300HP2.dts
@@ -42,12 +42,7 @@
 
                                partition@50000 {
                                        label = "firmware";
-                                       reg = <0x50000 0x5b0000>;
-                               };
-
-                               partition@600000 {
-                                       label = "usercfg";
-                                       reg = <0x600000 0x100000>;
+                                       reg = <0x50000 0x7b0000>;
                                };
                        };
                };
@@ -77,22 +72,26 @@
                ralink,port4 = "ephy";
        };
 
+       wmac@10180000 {
+               ralink,mtd-eeprom = <&factory 0>;
+       };
+
        gpio-leds {
                compatible = "gpio-leds";
                power {
                        label = "buffalo:red:power";
                        gpios = <&gpio0 7 1>;
                };
-               status {
-                       label = "buffalo:green:status";
+               wifi {
+                       label = "buffalo:green:wifi";
                        gpios = <&gpio0 8 1>;
                };
                power2 {
                        label = "buffalo:green:power";
                        gpios = <&gpio0 9 1>;
                };
-               status2 {
-                       label = "buffalo:orange:status";
+               wifi2 {
+                       label = "buffalo:orange:wifi";
                        gpios = <&gpio0 10 1>;
                };
                internet {
@@ -114,25 +113,27 @@
                #address-cells = <1>;
                #size-cells = <0>;
                poll-interval = <20>;
-               s1 {
+               reset {
                        label = "reset";
                        gpios = <&gpio2 12 1>;
-                       linux,code = <0x100>;
+                       linux,code = <0x198>;
                };
-               s2 {
+               aoss {
                        label = "aoss";
                        gpios = <&gpio2 13 1>;
-                       linux,code = <0x101>;
+                       linux,code = <0x211>;
                };
-               s3 {
+               ap {
                        label = "ap";
                        gpios = <&gpio2 14 1>;
-                       linux,code = <0x102>;
+                       linux,code = <0x100>;
+                       linux,input-type = <5>; /* EV_SW */
                };
-               s4 {
+               bridge {
                        label = "bridge";
                        gpios = <&gpio2 15 1>;
-                       linux,code = <0x103>;
+                       linux,code = <0x100>;
+                       linux,input-type = <5>; /* EV_SW */
                };
        };
 };