+msgid ""
+"The OLSR daemon is an implementation of the Optimized Link State Routing "
+"protocol. As such it allows mesh routing for any network equipment. It runs "
+"on any wifi card that supports ad-hoc mode and of course on any ethernet "
+"device. Visit <a href='http://www.olsr.org'>olsrd.org</a> for help and "
+"documentation."
+msgstr ""
+
+msgid ""
+"The fixed willingness to use. If not set willingness will be calculated "
+"dynamically based on battery/power status. Default is \"3\"."
+msgstr ""
+
+msgid "The interface OLSRd should serve."
+msgstr ""
+
+msgid ""
+"The port OLSR uses. This should usually stay at the IANA assigned port 698. "
+"It can have a value between 1 and 65535."
+msgstr ""
+
+msgid ""
+"This can be used to signal the external IPv6 prefix of the uplink to the "
+"clients. This might allow a client to change it's local IPv6 address to use "
+"the IPv6 gateway without any kind of address translation. The maximum prefix "
+"length is 64 bits. Default is \"::/0\" (no prefix)."
+msgstr ""
+
+msgid "Timing and Validity"
+msgstr ""
+
+msgid "Topology"
+msgstr ""
+
+msgid ""
+"Type of service value for the IP header of control traffic. Default is "
+"\"16\"."
+msgstr ""
+
+msgid "Unable to connect to the OLSR daemon!"
+msgstr ""
+
+msgid "Uplink"
+msgstr ""
+
+msgid "Uplink uses NAT"
+msgstr ""
+
+msgid "Use hysteresis"
+msgstr ""
+
+msgid "Version"
+msgstr ""
+
+msgid "WLAN"
+msgstr ""
+
+msgid ""
+"Warning: kmod-ipip is not installed. Without kmod-ipip SmartGateway will not "
+"work, please install it."
+msgstr ""
+
+msgid "Weight"
+msgstr ""
+
+msgid ""
+"When multiple links exist between hosts the weight of interface is used to "
+"determine the link to use. Normally the weight is automatically calculated "
+"by olsrd based on the characteristics of the interface, but here you can "
+"specify a fixed value. Olsrd will choose links with the lowest value.<br /"
+"><b>Note:</b> Interface weight is used only when LinkQualityLevel is set to "
+"0. For any other value of LinkQualityLevel, the interface ETX value is used "
+"instead."
+msgstr ""
+
+msgid ""
+"Which kind of uplink is exported to the other mesh nodes. An uplink is "
+"detected by looking for a local HNA of 0.0.0.0/0, ::ffff:0:0/96 or 2000::/3. "
+"Default setting is \"both\"."