ltq-vdsl-app: make it possible to configure ADSL/VDSL independently

[openwrt.git] / package / network / config / ltq-vdsl-app / files / dsl_control

diff --git a/package/network/config/ltq-vdsl-app/files/dsl_control b/package/network/config/ltq-vdsl-app/files/dsl_control
index 48c0cbe..6d254da 100644 (file)
--- a/package/network/config/ltq-vdsl-app/files/dsl_control
+++ b/package/network/config/ltq-vdsl-app/files/dsl_control
@@ -162,6 +162,8 @@ start_service() {
        local tone_adsl
        local tone_vdsl
        local xtse
+       local xfer_mode
+       local line_mode
        local mode
        local lowlevel
 
@@ -170,6 +172,7 @@ start_service() {
        config_get annex dsl annex
        config_get firmware dsl firmware
        config_get xfer_mode dsl xfer_mode
+       config_get line_mode dsl line_mode
 
        eval "xtse=\"\${xtse_xdsl_$annex}\""
 
@@ -179,14 +182,27 @@ start_service() {
        atm)
                LOAD=ltq_atm_vr9
                UNLOAD=ltq_ptm_vr9
+
+               # in most cases atm is used on top of adsl
+               [ -z "${line_mode}" ] && line_mode=adsl
+               ;;
+       *)
+               LOAD=ltq_ptm_vr9
+               UNLOAD=ltq_atm_vr9
+
+               # in most cases ptm is used on top of vdsl
+               [ -z "${line_mode}" ] && line_mode=vdsl
+               ;;
+       esac
+
+       case "${line_mode}" in
+       adsl)
                mode=1
 
                # mask out VDSL bits when ATM is requested
                xtse="${xtse%_*}_00"
                ;;
        *)
-               LOAD=ltq_ptm_vr9
-               UNLOAD=ltq_atm_vr9
                mode=2
                ;;
        esac