msgid "-- custom --"
msgstr "-- custom --"
+msgid "-- match by device --"
+msgstr ""
+
+msgid "-- match by label --"
+msgstr ""
+
msgid "1 Minute Load:"
msgstr "1 Minute Load:"
msgid "ADSL Status"
msgstr ""
+msgid "AICCU (SIXXS)"
+msgstr ""
+
msgid "APN"
msgstr "APN"
msgid "ATM device number"
msgstr "ATM device number"
+msgid "AYIYA"
+msgstr ""
+
msgid "Access Concentrator"
msgstr "Access Concentrator"
msgstr ""
"Allow upstream responses in the 127.0.0.0/8 range, e.g. for RBL services"
-msgid "Always announce default router"
+msgid ""
+"Also see <a href=\"https://www.sixxs.net/faq/connectivity/?faq=comparison"
+"\">Tunneling Comparison</a> on SIXXS"
msgstr ""
-msgid ""
-"Always use 40MHz channels even if the secondary channel overlaps. Using this "
-"option does not comply with IEEE 802.11n-2009!"
+msgid "Always announce default router"
msgstr ""
msgid "An additional network will be created if you leave this unchecked."
msgid "Atheros 802.11%s Wireless Controller"
msgstr ""
+msgid "AuthGroup"
+msgstr ""
+
msgid "Authentication"
msgstr "Authentication"
msgid "Band"
msgstr ""
+msgid "Behind NAT"
+msgstr ""
+
msgid ""
"Below is the determined list of files to backup. It consists of changed "
"configuration files marked by opkg, essential base files and the user "
msgid "Buttons"
msgstr "Buttons"
+msgid "CA certificate; if empty it will be saved after the first connection."
+msgstr ""
+
msgid "CPU"
msgstr "CPU"
msgid "CPU usage (%)"
msgstr "CPU usage (%)"
-msgid "Cached"
-msgstr "Cached"
-
msgid "Cancel"
msgstr "Cancel"
msgid "Configuration files will be kept."
msgstr "Configuration files will be kept."
-msgid "Configures this mount as overlay storage for block-extroot"
-msgstr "Configures this mount as overlay storage for block-extroot"
-
msgid "Confirmation"
msgstr "Confirmation"
msgid "Connection Limit"
msgstr "Connection Limit"
+msgid "Connection to server fails when TLS cannot be used"
+msgstr ""
+
msgid "Connections"
msgstr "Connections"
msgid "Default gateway"
msgstr "Default gateway"
+msgid "Default route"
+msgstr ""
+
msgid "Default state"
msgstr "Default state"
msgid "Enable VLAN functionality"
msgstr ""
+msgid "Enable WPS pushbutton, requires WPA(2)-PSK"
+msgstr ""
+
msgid "Enable learning and aging"
msgstr ""
+msgid "Enable mirroring of incoming packets"
+msgstr ""
+
+msgid "Enable mirroring of outgoing packets"
+msgstr ""
+
msgid "Enable this mount"
msgstr ""
msgid "Force"
msgstr "Force"
-msgid "Force 40MHz mode"
-msgstr ""
-
msgid "Force CCMP (AES)"
msgstr ""
msgid "Free space"
msgstr ""
-msgid "Frequency Hopping"
-msgstr "Frequency Hopping"
-
msgid "GHz"
msgstr ""
msgid "HE.net username"
msgstr ""
-msgid "HT mode (802.11n)"
-msgstr ""
-
msgid "Handler"
msgstr "Handler"
msgid "Hang Up"
msgstr "Hang Up"
+msgid "Heartbeat"
+msgstr ""
+
msgid ""
"Here you can configure the basic aspects of your device like its hostname or "
"the timezone."
msgid "Hostnames"
msgstr "Hostnames"
+msgid "Hybrid"
+msgstr ""
+
msgid "IP address"
msgstr "IP address"
msgid "IPv6 Firewall"
msgstr ""
+msgid "IPv6 Neighbours"
+msgstr ""
+
msgid "IPv6 Settings"
msgstr ""
msgid "IPv6 address"
msgstr ""
+msgid "IPv6 address delegated to the local tunnel endpoint (optional)"
+msgstr ""
+
msgid "IPv6 assignment hint"
msgstr ""
msgid "Interfaces"
msgstr "Interfaces"
+msgid "Internal"
+msgstr ""
+
msgid "Internal Server Error"
msgstr ""
msgid "Language and Style"
msgstr ""
+msgid "Leaf"
+msgstr ""
+
msgid "Lease validity time"
msgstr ""
msgid "Localise queries"
msgstr "Localise queries"
-msgid "Locked to channel %d used by %s"
+msgid "Locked to channel %d used by: %s"
msgstr ""
msgid "Log output level"
msgid "MTU"
msgstr ""
+msgid ""
+"Make sure to clone the root filesystem using something like the commands "
+"below:"
+msgstr ""
+
msgid "Maximum Rate"
msgstr "Maximum Rate"
msgid "Minimum hold time"
msgstr "Minimum hold time"
+msgid "Mirror monitor port"
+msgstr ""
+
+msgid "Mirror source port"
+msgstr ""
+
msgid "Missing protocol extension for proto %q"
msgstr ""
msgid "NTP server candidates"
msgstr ""
+msgid "NTP sync time-out"
+msgstr ""
+
msgid "Name"
msgstr "Name"
msgid "Open list..."
msgstr ""
+msgid "OpenConnect (CISCO AnyConnect)"
+msgstr ""
+
+msgid "Operating frequency"
+msgstr ""
+
msgid "Option changed"
msgstr ""
msgid "Option removed"
msgstr ""
+msgid "Optional, specify to override default server (tic.sixxs.net)"
+msgstr ""
+
+msgid "Optional, use when the SIXXS account has more than one tunnel"
+msgstr ""
+
msgid "Options"
msgstr "Options"
msgid "Outdoor Channels"
msgstr "Outdoor Channels"
+msgid "Output Interface"
+msgstr ""
+
msgid "Override MAC address"
msgstr ""
msgid "Password successfully changed!"
msgstr ""
+msgid "Path"
+msgstr "Path"
+
msgid "Path to CA-Certificate"
msgstr "Path to CA-Certificate"
msgid "Request IPv6-prefix of length"
msgstr ""
+msgid "Require TLS"
+msgstr ""
+
msgid "Required for certain ISPs, e.g. Charter with DOCSIS 3"
msgstr ""
msgid "Root directory for files served via TFTP"
msgstr ""
+msgid "Root preparation"
+msgstr ""
+
+msgid "Routed IPv6 prefix for downstream interfaces"
+msgstr ""
+
msgid "Router Advertisement-Service"
msgstr ""
msgid "Run filesystem check"
msgstr ""
+msgid ""
+"SIXXS supports TIC only, for static tunnels using IP protocol 41 (RFC4213) "
+"use 6in4 instead"
+msgstr ""
+
+msgid "SIXXS-handle[/Tunnel-ID]"
+msgstr ""
+
msgid "SSH Access"
msgstr ""
msgid "Server Settings"
msgstr ""
+msgid "Server password"
+msgstr ""
+
+msgid ""
+"Server password, enter the specific password of the tunnel when the username "
+"contains the tunnel ID"
+msgstr ""
+
+msgid "Server username"
+msgstr ""
+
msgid "Service Name"
msgstr ""
msgid "Source"
msgstr "Source"
+msgid "Source routing"
+msgstr ""
+
msgid "Specifies the button state to handle"
msgstr "Specifies the button state to handle"
"settings."
msgid ""
+"The tunnel end-point is behind NAT, defaults to disabled and only applies to "
+"AYIYA"
+msgstr ""
+
+msgid ""
"The uploaded image file does not contain a supported format. Make sure that "
"you choose the generic image format for your platform."
msgstr ""
msgid "Tunnel Link"
msgstr ""
+msgid "Tunnel broker protocol"
+msgstr ""
+
+msgid "Tunnel setup server"
+msgstr ""
+
+msgid "Tunnel type"
+msgstr ""
+
msgid "Turbo Mode"
msgstr "Turbo Mode"
msgid "Use TTL on tunnel interface"
msgstr ""
-msgid "Use as root filesystem"
+msgid "Use as external overlay (/overlay)"
+msgstr ""
+
+msgid "Use as root filesystem (/)"
msgstr ""
msgid "Use broadcast flag"
msgid "Used Key Slot"
msgstr ""
+msgid "User certificate (PEM encoded)"
+msgstr ""
+
+msgid "User key (PEM encoded)"
+msgstr ""
+
msgid "Username"
msgstr "Username"
msgid "VPN Server"
msgstr ""
+msgid "VPN Server port"
+msgstr ""
+
+msgid "VPN Server's certificate SHA1 hash"
+msgstr ""
+
msgid "Vendor Class to send when requesting DHCP"
msgstr ""
+msgid "Verbose"
+msgstr ""
+
+msgid "Verbose logging by aiccu daemon"
+msgstr ""
+
msgid "Verify"
msgstr ""
"WPA-Encryption requires wpa_supplicant (for client mode) or hostapd (for AP "
"and ad-hoc mode) to be installed."
+msgid ""
+"Wait for NTP sync that many seconds, seting to 0 disables waiting (optional)"
+msgstr ""
+
msgid "Waiting for changes to be applied..."
msgstr ""
msgid "Warning: There are unsaved changes that will be lost while rebooting!"
msgstr "Warning: There are unsaved changes that will be lost while rebooting!"
+msgid "Whether to create an IPv6 default route over the tunnel"
+msgstr ""
+
+msgid "Whether to route only packets from delegated prefixes"
+msgstr ""
+
+msgid "Width"
+msgstr ""
+
msgid "Wifi"
msgstr "Wifi"
"You must enable Java Script in your browser or LuCI will not work properly."
msgstr ""
+msgid ""
+"Your Internet Explorer is too old to display this page correctly. Please "
+"upgrade it to at least version 7 or use another browser like Firefox, Opera "
+"or Safari."
+msgstr ""
+
msgid "any"
msgstr ""
msgid "local <abbr title=\"Domain Name System\">DNS</abbr> file"
msgstr "local <abbr title=\"Domain Name System\">DNS</abbr> file"
+msgid "minimum 1280, maximum 1480"
+msgstr ""
+
+msgid "navigation Navigation"
+msgstr ""
+
msgid "no"
msgstr ""
msgid "none"
msgstr "none"
+msgid "not present"
+msgstr ""
+
msgid "off"
msgstr ""
msgid "open"
msgstr ""
+msgid "overlay"
+msgstr ""
+
msgid "relay mode"
msgstr ""
msgid "server mode"
msgstr ""
+msgid "skiplink1 Skip to navigation"
+msgstr ""
+
+msgid "skiplink2 Skip to content"
+msgstr ""
+
msgid "stateful-only"
msgstr ""
msgid "« Back"
msgstr "« Back"
+#~ msgid "Cached"
+#~ msgstr "Cached"
+
+#~ msgid "Configures this mount as overlay storage for block-extroot"
+#~ msgstr "Configures this mount as overlay storage for block-extroot"
+
+#~ msgid "Frequency Hopping"
+#~ msgstr "Frequency Hopping"
+
#~ msgid "40MHz 2nd channel above"
#~ msgstr "40MHz 2nd channel above"
#~ msgid "Number of leased addresses"
#~ msgstr "Number of leased addresses"
-#~ msgid "Path"
-#~ msgstr "Path"
-
#~ msgid "Perform Actions"
#~ msgstr "Perform Actions"
projects / project / luci.git / blobdiff