[tools] dosfstools: link statically
[openwrt.git] / target /
2012-08-10 florian[mcs814x] nuport-mac: delay call to napi_start() until...
2012-08-10 florian[mcs814x] set a compatible command-line to boot from...
2012-08-10 juhosggeneric: rtl8366_smi: increase delay after switch hw...
2012-08-09 jowFix hard reset of alix/soekris hardware under heavy...
2012-08-09 florian[mcs814x] nuport-mac: use dma_mapping_error() instead...
2012-08-08 florian[mcs814x] nuport-mac: rework PHY interrupt configuratio...
2012-08-08 florian[mcs814x] nuport-mac: close possible race condition...
2012-08-08 florian[mcs814x] nuport-mac: unmap the DMA buffer when closing...
2012-08-08 florian[mcs814x] nuport-mac: check dma_map_single address...
2012-08-08 florian[mcs814x] build a Devolo dLAN USB Extender specific...
2012-08-08 florian[mcs814x] cleanup image generation
2012-08-08 blogic[lantiq] pci gpio mapping
2012-08-05 jogobcm63xx: fix USB base registers and IRQs for BCM6328
2012-08-05 hauke[brcm47xx] update tg3 driver
2012-08-05 hauke[brcm47xx] generate image for Linksys e3200
2012-08-05 haukebrcm47xx: update gpio patch
2012-08-05 haukebrcm47xx: fix patch which moves the flash struct in...
2012-08-04 blogic[lantiq] W502V/ARV4525 wireless mac bugfix
2012-08-04 haukebrcm47xx: use libgpio instaed of implementing the gpio...
2012-08-03 blogic[lantiq] cleanup patches
2012-08-02 florian[mcs814x] nuport-mac: properly protect the phy interrup...
2012-08-02 blogic[bufferbloat] Codel: avoid a nul rec_inv_sqrt
2012-08-02 blogic[lantiq] fixes i2c clock enable
2012-08-02 juhosgar71xx: simplify misc IRQ handling
2012-08-02 juhosgar71xx: fix AR934X_EHCI_SIZE
2012-08-02 juhosgar71xx: image: stop the switch from the lzma-loader...
2012-08-02 juhosgar71xx: image: allow to use board specific code in...
2012-08-02 juhosgar71xx: init switch hw_reset on the TL-WR1043ND board
2012-08-02 juhosggeneric: rtl836x: add hw_reset field to struct rtl8366_smi
2012-08-02 juhosggeneric: rtl8366_smi: use __rtl8366_smi_cleanup instead...
2012-08-01 florian[mcs814x] add missing netmask to the network config
2012-08-01 florian[mcs814x] assume the link is up and full-duplex by...
2012-08-01 florian[mcs814x] add a default and suitable network config...
2012-08-01 juhosgar71xx: ew-dorin: added router firmware generation
2012-08-01 juhosgar71xx: ew-dorin: added USB support
2012-08-01 juhosgar71xx: Buffalo WLAE-AG300N wireless led patch
2012-08-01 juhosgar71xx: Buffalo WLAE-AG300N initial support
2012-08-01 florian[mcs814x] resync defconfig enable XZ compression
2012-07-31 florian[mcs814x] properly generate squashfs, jffs2 and initram...
2012-07-31 florian[kernel] disable crashlog on ARM platforms for the...
2012-07-31 blogic[lantiq] add lantiq svip support
2012-07-31 jogobcm63xx: Add nb6 support (BCM6362 SoC base boards)
2012-07-31 jogobcm63xx: add basic bcm6362 support
2012-07-31 jogobcm63xx: enable usb for bcm6328
2012-07-31 jogobcm63xx: update enetswitch driver
2012-07-31 jogobcm63xx: reorder patches
2012-07-29 florian[at91] move i2c module to target modules.mk
2012-07-29 florian[omap24xx] resync config
2012-07-29 florian[omap24xx] use the same description as other omap platf...
2012-07-29 blogic[kernel] refresh pwm patch
2012-07-28 blogic[kernel] clean up pwm patches and drivers
2012-07-28 hauke[kernel] add config option CONFIG_I2C_MV64XXX to fix...
2012-07-27 florian[realview] resync config
2012-07-27 florian[brcm63xx] fix DVA-G3810BN image generation
2012-07-27 florian[brcm63xx] add D-link DVA-G3810BN-TL-1 support
2012-07-27 florian[brcm63xx] Add CT6376-1 board support
2012-07-27 florian[brcm63xx] Add brcmsmac profile
2012-07-26 blogic[atheros] Add leds back after migration to sysfs
2012-07-26 florian[brcm2708] add more missing config symbols
2012-07-26 florian[generic] add more USB-related config symbols
2012-07-26 florian[ep93xx] make sure target modules depend on the target
2012-07-26 hauke[kernel] bcma: update to version from wireless-testing...
2012-07-25 blogic[ar71xx] fix typo in modules.mk
2012-07-25 florian[package] make kmod-fb dependent on DISPLAY_SUPPORT...
2012-07-25 florian[ppc40x] move isp116x driver to target specific modules.mk
2012-07-25 florian[ramips] move rt305x-dwc driver to target specific...
2012-07-25 florian[brcm47xx] move ubsec-ssb driver to target specific...
2012-07-25 florian[brcm47xx] move ssb-gige to target specific modules.mk
2012-07-25 florian[brcm47xx] move usb driver to target specific modules.mk
2012-07-25 florian[avr32] move mmc driver to target specific modules.mk
2012-07-25 florian[ixp4xx] move ixp4xx-eth to target specific modules.mk
2012-07-25 florian[ixp4xx] move crypto module to target specific modules.mk
2012-07-25 florian[octeon] move i2c driver to target modules.mk
2012-07-25 florian[ar71xx] move watchdog driver to target specific modules.mk
2012-07-25 florian[ar71xx] move target specific spi modules
2012-07-25 florian[ar71xx] move target specific leds modules to ar71xx...
2012-07-25 florian[x86] move leds modules back to target modules.mk
2012-07-25 florian[x86] move i2c modules back to target modules.mk
2012-07-25 florian[x86] move more x86-specific modules back to target...
2012-07-25 florian[x86] move x86 specific ide/pata modules to x86' modules.mk
2012-07-25 haukebrcm47xx: reorder patches so that the patches already...
2012-07-25 florian[kernel] add yet another framebuffer symbol
2012-07-25 florian[package] split framebuffer helper modules to their...
2012-07-25 florian[cobalt] remove broken flag
2012-07-25 florian[cobalt] package buttons driver separately
2012-07-25 florian[cobalt] package cobalt lcd as a module
2012-07-25 blogic[kernel] add unset CONFIG_FB_XGI to fix fullbuilds
2012-07-25 blogic[brcm2708] cleanup config-3.3, remove =m
2012-07-25 blogic[cns3xx] laguna: fix eeprom read buffer size during...
2012-07-24 blogic[brcm2708] adds target used by rapsberry pi
2012-07-24 blogic[ramips] DWC otg usb: compilation fixes and trivial...
2012-07-24 blogic[ramips] D-Link DAP-1350 initial support
2012-07-24 blogic[ixp4xx] MI424WR - add rev D support
2012-07-24 blogic[ramips] initial LED configuration for Fonera 2.0n
2012-07-24 blogic[ramips] add ALL5002 userspace support
2012-07-24 blogic[ramips] enable OHCI/EHCI glue on Rt305x, so it is...
2012-07-24 blogic[ramips] add image build for ALL5002
2012-07-24 blogic[ramips] add support for Allnet ALL5002 to kernel
2012-07-24 blogic[ramips] uart_clk on Rt3352F is always 40MHz
2012-07-24 florian[omap24xx] move omap specific modules to modules.mk
next