ar71xx: use a backported patch to fix AR933x UART baud rate calculation
[openwrt.git] / target /
2012-12-29 juhosgar71xx: use a backported patch to fix AR933x UART baud...
2012-12-28 nbdar71xx: change the unaligned access hack to assume...
2012-12-28 nbdmips: use -mno-branch-likely for kernel and userspace...
2012-12-27 nbdkernel: remove the cisco SIP NAT patch, at least on...
2012-12-27 haukebrcm47xx: bcma: correct M25P32 serial flash ID
2012-12-26 juhosgmpc83xx: add support for 3.7
2012-12-26 juhosgmpc83xx: nuke 3.3 support
2012-12-26 juhosgmpc83xx: switch to 3.6.11
2012-12-26 juhosgmpc83xx: add support for 3.6
2012-12-26 juhosgmpc83xx: create package for the rbppc_cf module
2012-12-26 juhosggeneric: more missing symbols for 3.{6,7}
2012-12-26 juhosgar71xx: build image for the AP136-020
2012-12-26 juhosgar71xx: add user-space support for AP136-020
2012-12-26 juhosgar71xx: add kernel support for the AP136-020 board
2012-12-26 juhosgar71xx: rename AP136 to AP136-010
2012-12-25 juhosgar71xx: dynamically set AR8327's PAD configuration...
2012-12-25 juhosggeneric: ar8216: add sgmii_delay_en field to ar8327_pla...
2012-12-25 juhosgar71xx: ag71xx: show PHY interface mode in dmesg
2012-12-24 juhosgramips: fix ASUS WL-330N3G MAC address
2012-12-24 juhosgramips: fix wifi EEPROM extraction on DIR-615-Dx models
2012-12-23 kaloz[cns3xxx]: add nol2x0 cmdline to disable l2x0 cache
2012-12-22 juhosggeneric: ar8216: don't use 0 as default VID on AR8327
2012-12-22 juhosggeneric: more missing symbols for 3.{6,7}
2012-12-22 juhosgramips: unify eeprom file name for the built-in wireles...
2012-12-22 juhosgramips: rt3883: fix build error
2012-12-22 juhosgar71xx: register the second ethernet interface on the...
2012-12-22 juhosgar71xx: fix ethernet device registration for QCA9558
2012-12-22 juhosgar71xx: rename QCA9558 ETH_CFG bit defines
2012-12-22 juhosgar71xx: fixup allowed PHY interface types for QCA9558
2012-12-22 juhosgar71xx: don't assign any MII bus device on QCA9558...
2012-12-22 juhosgar71xx: ag71xx: fix mii_bus_dev sanity check
2012-12-22 juhosgar71xx: ag71xx: don't start/stop built-in switch w...
2012-12-22 juhosggeneric: ar8316: allow to configure port 6 via platform...
2012-12-22 juhosggeneric: ar8216: rename cpuport_cfg to port0_cfg in...
2012-12-22 juhosgramips: add support for 3.7
2012-12-22 juhosgramips: convert to use {e,o}hci-platform driver
2012-12-22 juhosggeneric/3.6: add platform specific power callbacks...
2012-12-22 blogic[lantiq] ar9 did not load atm driver properly
2012-12-21 blogic[lantiq] dont use input layer for gpio buttons
2012-12-21 blogic[lantiq] default switch setup for WBMR
2012-12-21 blogic[lantiq] Setting the MDC clock to 2.5MHz and changing...
2012-12-21 blogic[lantiq] adds script to set wps info on boards with...
2012-12-21 blogic[lantiq] minor tweaks to WBMR image
2012-12-21 blogic[lantiq] add missing PHY_BASIC_FEATURES to 100mbit...
2012-12-21 blogic[lantiq] fix typo inside fritz3370 devicetree file
2012-12-21 blogic[lantiq] more devicetree fixes
2012-12-21 blogic[lantiq] improve button handling
2012-12-21 blogic[lantiq] add phy-reset gpio handling to xrx200-net
2012-12-21 blogic[lantiq] add more lantiq phy ids based on daniels uboot...
2012-12-21 blogic[lantiq] refresh patch and install v1.1 gphy blobs
2012-12-21 blogic[kernel] make to rtl8366_smi of binding use gpio_is_valid
2012-12-21 juhosgkernel: add solos-pci update for 3.3
2012-12-20 juhosgrb532: add support for 3.7
2012-12-20 juhosgramips: Add USB support for DAP-1350 platform.
2012-12-20 juhosgrb532: nuke 3.3 support
2012-12-20 juhosgrb532: switch to 3.6.11
2012-12-20 juhosgrb532: add support for 3.6
2012-12-20 juhosgppc44x: add support for 3.7
2012-12-20 juhosgkernel: add solos-pci patches from 3.8 for new hardware
2012-12-20 juhosglinux: add missing symbols for 3.{6,7}
2012-12-20 juhosgcns21xx: add support for 3.7
2012-12-20 juhosgppc40x: add support for 3.7
2012-12-20 juhosgppc40x: add missing NULL terminator to avoid boot panic...
2012-12-20 juhosgar71xx: rename fix-ar933x-reset patch
2012-12-20 juhosgppc40x/44x: disable SWIOTLB
2012-12-19 blogic[lantiq] adds a fix for ar8216 mii detection on etop...
2012-12-19 mirkomerge /lib/functions/boot.sh and /lib/functions.sh
2012-12-19 mirkoDo not use deprecated path to functions.sh (/etc/functi...
2012-12-19 mirkoDo not overload mount-call - trying to reduce confusion
2012-12-19 blogic[lantiq] minor basefiles fixes
2012-12-19 blogic[lantiq] fix gptu clocks
2012-12-19 blogic[lantiq] more board file fixes
2012-12-19 juhosgppc44x: nuke 3.3 support
2012-12-19 juhosgppc44x: switch to 3.6.11
2012-12-19 juhosgppc44x: add support for 3.6
2012-12-19 juhosgar71xx: merge machine patches
2012-12-19 juhosgar71xx: build image for the TL-MR3220 v2
2012-12-19 juhosgar71xx: add user-space support for the TL-MR3220 v2
2012-12-19 juhosgar71xx: add kernel support for the TL-MR3220 v2
2012-12-18 blogic[lantiq] fix gptu patch - tapi should now load
2012-12-18 juhosgppc40x: nuke 3.3 support
2012-12-18 juhosgppc40x: switch to 3.6.11
2012-12-18 juhosgppc40x: add support for 3.6
2012-12-18 juhosggeneric: disable crashlog on ppc
2012-12-18 juhosggeneric: add missing symbols for 3.{6,7}
2012-12-18 blogic[lantiq] update to 3.7.1
2012-12-18 juhosgetrax: R.I.P.
2012-12-18 juhosgs3c2442: R.I.P.
2012-12-18 juhosggoldfish: R.I.P.
2012-12-18 juhosgps3: R.I.P.
2012-12-18 juhosgpxcab: R.I.P.
2012-12-18 juhosgrefresh kernel configs with kconfig.pl
2012-12-18 juhosggeos: add missing config-3.7 file
2012-12-18 juhosgar71xx: image: add OpenMesh profile
2012-12-18 juhosgkernel: update linux 3.7 to 3.7.1
2012-12-18 juhosgcns21xx: remove broken flag
2012-12-18 juhosgcns21xx: nuke 3.3 support
2012-12-18 juhosgcns21xx: switch to 3.6.11
2012-12-18 juhosgcns21xx: fix build errors on 3.6
2012-12-18 juhosggeos: update to 3.7
next