ramips: preinit: use iproute2 instead of vconfig

Replace use of vconfig with the corresponding iproute2 syntax in
/lib/preinit/07_set_preinit_iface_ramips

The switch reset work-around needed on some ramips targets used the
deprecated vconfig tool to bring up the pre-init/failsafe interface.
This doesn't work on recent builds where vconfig is no longer being
deployed, resulting in the device being unreachable when triggered
into failsafe mode.

Signed-off-by: Daniel Golle <daniel@makrotopia.org>
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@47349 3c298f89-4303-0410-b956-a3cf2f4a3e73

diff --git a/target/linux/ramips/base-files/lib/preinit/07_set_preinit_iface_ramips b/target/linux/ramips/base-files/lib/preinit/07_set_preinit_iface_ramips
index 90b6d15..3dce1b6 100644 (file)
--- a/target/linux/ramips/base-files/lib/preinit/07_set_preinit_iface_ramips
+++ b/target/linux/ramips/base-files/lib/preinit/07_set_preinit_iface_ramips
@@ -23,8 +23,8 @@ ramips_set_preinit_iface() {
                swconfig dev rt305x vlan 1 set ports "0 6"
                swconfig dev rt305x port 6 set untag 0
                swconfig dev rt305x set apply 1
                swconfig dev rt305x vlan 1 set ports "0 6"
                swconfig dev rt305x port 6 set untag 0
                swconfig dev rt305x set apply 1

-               vconfig add eth0 1
-               ifconfig eth0 up
+               ip link add link eth0 name eth0.1 type vlan id 1
+               ip link set eth0 up

                ifname=eth0.1
        else
                ifname=eth0
                ifname=eth0.1
        else
                ifname=eth0