ltq-vdsl-app: use VDSL tone-setup if annex is unset

I had to use a VDSL-only tone-setup to get show-time.
Handle this in uci by checking if annex is unset.

Signed-off-by: Daniel Golle <daniel@makrotopia.org>
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@43114 3c298f89-4303-0410-b956-a3cf2f4a3e73

diff --git a/package/network/config/ltq-vdsl-app/files/dsl_control b/package/network/config/ltq-vdsl-app/files/dsl_control
index 4bfea97..bededb2 100644 (file)
--- a/package/network/config/ltq-vdsl-app/files/dsl_control
+++ b/package/network/config/ltq-vdsl-app/files/dsl_control
@@ -131,6 +131,7 @@ start() {
        local tone
        local tone_adsl
        local tone_vdsl
+       local xtse
        local xtse_adsl
        local mode
 
@@ -154,7 +155,12 @@ start() {
        esac
 
        eval "xtse_adsl=\"\${xtse_adsl_$annex}\""
-       [ -z "${xtse_adsl}" ] && xtse_adsl=$xtse_adsl_a
+       if [ "${xtse_adsl}" ]; then
+               xtse=$xtse_adsl
+       else
+               xtse_adsl=$xtse_adsl_a
+               xtse=$xtse_vdsl
+       fi
 
        eval "tone_adsl=\"\${tone_adsl_$tone}\""
        [ -z "${tone_adsl}" ] && tone_adsl=$tone_adsl_av
@@ -173,7 +179,7 @@ start() {
        lowlevel_cfg "${tone_adsl}" "${tone_vdsl}"
 
        service_start /sbin/vdsl_cpe_control \
-                       -i `echo $xtse_adsl | sed "s/ /_/g"` \
+                       -i `echo $xtse | sed "s/ /_/g"` \
                        -n /sbin/dsl_notify.sh \
                        -f ${firmware} \
                        -a /tmp/adsl.scr \