X-Git-Url: https://git.archive.openwrt.org/?p=openwrt.git;a=blobdiff_plain;f=docs%2Fnetwork.tex;h=cf1200dcd43e0081ebfea483cf4087d92414e86b;hp=5516bd9a300e4f2338eea56e3696fdb3d84a2dc2;hb=85c05af15dfb5fb72b970ebe16c1d86df98d1538;hpb=f4c5e720c8236616cf1352bd3d652778a097fa15

diff --git a/docs/network.tex b/docs/network.tex
index 5516bd9a30..cf1200dcd4 100644
--- a/docs/network.tex
+++ b/docs/network.tex
@@ -107,7 +107,7 @@ The name for the route section is optional, the \texttt{interface}, \texttt{targ
 \texttt{gateway} options are mandatory.
 Leaving out the \texttt{netmask} option will turn the route into a host route.
 
-\subsubsection{Setting up the switch (currently broadcom only)}
+\subsubsection{Setting up the switch (broadcom only)}
 
 The switch configuration is set by adding a \texttt{'switch'} config section.
 Example:
@@ -152,6 +152,27 @@ Three interfaces will be automatically created using this switch layout :
 You can then assign those interfaces to a custom network configuration name
 like \texttt{lan}, \texttt{wan} or \texttt{dmz} for instance.
 
+\subsubsection{Setting up the switch (swconfig)}
+
+\emph{swconfig} based configurations have a different structure with one extra
+section per vlan. The example below shows a typical configuration:
+
+\begin{Verbatim}
+config 'switch' 'eth0'
+        option 'reset' '1'
+        option 'enable_vlan' '1'
+
+config 'switch_vlan' 'eth0_1'
+        option 'device' 'eth0'
+        option 'vlan' '1'
+        option 'ports' '0 1 2 3 5t'
+
+config 'switch_vlan' 'eth0_2'
+        option 'device' 'eth0'
+        option 'vlan' '2'
+        option 'ports' '4 5t'
+\end{Verbatim}
+
 \subsubsection{Setting up IPv6 connectivity}
 
 OpenWrt supports IPv6 connectivity using PPP, Tunnel brokers or static