lantiq: use dwc2 by default on all ar9 boards

[openwrt.git] / target / linux / lantiq / xrx200 / config-default

diff --git a/target/linux/lantiq/xrx200/config-default b/target/linux/lantiq/xrx200/config-default
index a55e497..1c9f5cc 100644 (file)
--- a/target/linux/lantiq/xrx200/config-default
+++ b/target/linux/lantiq/xrx200/config-default
@@ -3,7 +3,6 @@ CONFIG_AR8216_PHY=y
 # CONFIG_ARCH_HAS_SG_CHAIN is not set
 CONFIG_ARCH_MIGHT_HAVE_PC_PARPORT=y
 CONFIG_ARCH_MIGHT_HAVE_PC_SERIO=y
-# CONFIG_ARCH_NEEDS_CPU_IDLE_COUPLED is not set
 CONFIG_CLONE_BACKWARDS=y
 CONFIG_CPU_NEEDS_NO_SMARTMIPS_OR_MICROMIPS=y
 CONFIG_CPU_SUPPORTS_MSA=y
@@ -30,7 +29,6 @@ CONFIG_INPUT_POLLDEV=y
 CONFIG_IRQCHIP=y
 CONFIG_IRQ_WORK=y
 # CONFIG_ISDN is not set
-CONFIG_KERNFS=y
 CONFIG_LANTIQ_PHY=y
 CONFIG_LANTIQ_XRX200=y
 CONFIG_LEDS_TRIGGER_HEARTBEAT=y
@@ -42,7 +40,6 @@ CONFIG_MTD_NAND_ECC=y
 CONFIG_MTD_NAND_PLATFORM=y
 CONFIG_MTD_NAND_XWAY=y
 # CONFIG_MTD_PHYSMAP_OF is not set
-CONFIG_MTD_SPLIT_SUPPORT=y
 CONFIG_MTD_UBI=y
 CONFIG_MTD_UBI_BEB_LIMIT=20
 CONFIG_MTD_UBI_BLOCK=y
@@ -53,17 +50,14 @@ CONFIG_NLS=y
 # CONFIG_NO_IOPORT_MAP is not set
 CONFIG_OF_ADDRESS_PCI=y
 CONFIG_PCIE_LANTIQ=y
-# CONFIG_PCI_LANTIQ is not set
 # CONFIG_RCU_STALL_COMMON is not set
 CONFIG_RTL8306_PHY=y
 CONFIG_RTL8366S_PHY=y
 CONFIG_RTL8367B_PHY=y
 CONFIG_RTL8367_PHY=y
 CONFIG_SPI=y
-CONFIG_SPI_BITBANG=y
-CONFIG_SPI_GPIO=y
+CONFIG_SPI_LANTIQ=y
 CONFIG_SPI_MASTER=y
-CONFIG_SPI_XWAY=y
 CONFIG_SYS_SUPPORTS_MIPS16=y
 CONFIG_UBIFS_FS=y
 CONFIG_UBIFS_FS_ADVANCED_COMPR=y