ramips: Change all '/include/' clauses to '#include' so preprocessing can be done...
[openwrt.git] / target / linux / ramips / dts / BROADWAY.dts
1 /dts-v1/;
2
3 #include "rt3050.dtsi"
4
5 / {
6         compatible = "BROADWAY", "ralink,rt3052-soc";
7         model = "Hauppauge Broadway";
8
9         pinctrl {
10                 state_default: pinctrl0 {
11                         gpio {
12                                 ralink,group = "spi", "i2c", "jtag", "rgmii", "mdio", "uartf";
13                                 ralink,function = "gpio";
14                         };
15                 };
16         };
17
18         cfi@1f000000 {
19                 compatible = "cfi-flash";
20                 reg = <0x1f000000 0x800000>;
21                 bank-width = <2>;
22                 device-width = <2>;
23                 #address-cells = <1>;
24                 #size-cells = <1>;
25
26                 partition@0 {
27                         label = "bootloader";
28                         reg = <0x0 0x30000>;
29                         read-only;
30                 };
31
32                 partition@30000 {
33                         label = "config";
34                         reg = <0x30000 0x10000>;
35                         read-only;
36                 };
37
38                 factory: partition@40000 {
39                         label = "factory";
40                         reg = <0x40000 0x10000>;
41                         read-only;
42                 };
43
44                 partition@50000 {
45                         label = "firmware";
46                         reg = <0x50000 0x790000>;
47                 };
48         };
49
50         ethernet@10100000 {
51                 mtd-mac-address = <&factory 0x4>;
52         };
53
54         esw@10110000 {
55                 mediatek,portmap = <0x3e>;
56         };
57
58         wmac@10180000 {
59                 ralink,mtd-eeprom = <&factory 0>;
60         };
61
62         gpio-leds {
63                 compatible = "gpio-leds";
64
65                 diskmounted {
66                         label = "broadway:red:diskmounted";
67                         gpios = <&gpio0 9 1>;
68                 };
69
70                 wps_active {
71                         label = "broadway:red:wps_active";
72                         gpios = <&gpio0 14 1>;
73                 };
74         };
75
76         gpio-keys-polled {
77                 compatible = "gpio-keys-polled";
78                 #address-cells = <1>;
79                 #size-cells = <0>;
80                 poll-interval = <20>;
81
82                 factory {
83                         label = "Factory Reset button";
84                         gpios = <&gpio0 13 1>;
85                         linux,code = <0x198>;
86                 };
87         };
88
89         otg@101c0000 {
90                 status = "okay";
91         };
92 };