2 * Copyright 2013 Gateworks Corporation
4 * The code contained herein is licensed under the GNU General Public
5 * License. You may obtain a copy of the GNU General Public License
6 * Version 2 or later at the following locations:
8 * http://www.opensource.org/licenses/gpl-license.html
9 * http://www.gnu.org/copyleft/gpl.html
13 /* these are used by bootloader for disabling nodes */
31 compatible = "gpio-leds";
35 gpios = <&gpio4 6 0>; /* 102 -> MX6_PANLEDG */
37 linux,default-trigger = "heartbeat";
42 gpios = <&gpio4 7 0>; /* 103 -> MX6_PANLEDR */
43 default-state = "off";
48 gpios = <&gpio4 15 1>; /* 111 - MX6_LOCLED# */
49 default-state = "off";
54 reg = <0x10000000 0x20000000>;
58 compatible = "simple-bus";
61 compatible = "regulator-fixed";
62 regulator-name = "1P0V";
63 regulator-min-microvolt = <1000000>;
64 regulator-max-microvolt = <1000000>;
68 /* remove this fixed regulator once ltc3676__sw2 driver available */
70 compatible = "regulator-fixed";
71 regulator-name = "1P8V";
72 regulator-min-microvolt = <1800000>;
73 regulator-max-microvolt = <1800000>;
78 compatible = "regulator-fixed";
79 regulator-name = "3P3V";
80 regulator-min-microvolt = <3300000>;
81 regulator-max-microvolt = <3300000>;
86 compatible = "regulator-fixed";
87 regulator-name = "5P0V";
88 regulator-min-microvolt = <5000000>;
89 regulator-max-microvolt = <5000000>;
93 reg_usb_otg_vbus: usb_otg_vbus {
94 compatible = "regulator-fixed";
95 regulator-name = "usb_otg_vbus";
96 regulator-min-microvolt = <5000000>;
97 regulator-max-microvolt = <5000000>;
104 compatible = "fsl,imx6q-ventana-sgtl5000",
105 "fsl,imx-audio-sgtl5000";
106 model = "sgtl5000-audio";
107 ssi-controller = <&ssi1>;
108 audio-codec = <&codec>;
110 "MIC_IN", "Mic Jack",
111 "Mic Jack", "Mic Bias",
112 "Headphone Jack", "HP_OUT";
119 pinctrl-names = "default";
120 pinctrl-0 = <&pinctrl_audmux_1>;
125 pinctrl-names = "default";
126 pinctrl-0 = <&pinctrl_flexcan1_1>;
131 pinctrl-names = "default";
132 pinctrl-0 = <&pinctrl_enet_1>;
134 phy-reset-gpios = <&gpio1 30 0>;
139 pinctrl-names = "default";
140 pinctrl-0 = <&pinctrl_gpmi_nand_2>;
145 clock-frequency = <100000>;
146 pinctrl-names = "default";
147 pinctrl-0 = <&pinctrl_i2c1_1>;
151 compatible = "atmel,24c02";
157 compatible = "atmel,24c02";
163 compatible = "atmel,24c02";
169 compatible = "atmel,24c02";
175 compatible = "nxp,pca9555";
182 compatible = "gw,gsp";
187 compatible = "dallas,ds1672";
193 clock-frequency = <100000>;
194 pinctrl-names = "default";
195 pinctrl-0 = <&pinctrl_i2c2_2>;
198 pciswitch: pex8609@3f {
199 compatible = "plx,pex8609";
204 compatible = "ltc,ltc3676";
208 sw1_reg: ltc3676__sw1 {
209 regulator-min-microvolt = <1175000>;
210 regulator-max-microvolt = <1175000>;
215 sw2_reg: ltc3676__sw2 {
216 regulator-min-microvolt = <1800000>;
217 regulator-max-microvolt = <1800000>;
222 sw3_reg: ltc3676__sw3 {
223 regulator-min-microvolt = <1175000>;
224 regulator-max-microvolt = <1175000>;
229 sw4_reg: ltc3676__sw4 {
230 regulator-min-microvolt = <1500000>;
231 regulator-max-microvolt = <1500000>;
236 ldo2_reg: ltc3676__ldo2 {
237 regulator-min-microvolt = <2500000>;
238 regulator-max-microvolt = <2500000>;
243 ldo3_reg: ltc3676__ldo3 {
244 regulator-min-microvolt = <1800000>;
245 regulator-max-microvolt = <1800000>;
250 ldo4_reg: ltc3676__ldo4 {
251 regulator-min-microvolt = <3000000>;
252 regulator-max-microvolt = <3000000>;
259 clock-frequency = <100000>;
260 pinctrl-names = "default";
261 pinctrl-0 = <&pinctrl_i2c3_2>;
264 accelerometer: fxos8700@1e {
265 compatible = "fsl,fxos8700";
270 compatible = "fsl,sgtl5000";
272 clocks = <&clks 169>;
273 VDDA-supply = <®_1p8v>;
274 VDDIO-supply = <®_3p3v>;
277 touchscreen: egalax_ts@04 {
278 compatible = "eeti,egalax_ts";
280 interrupt-parent = <&gpio7>;
281 interrupts = <12 2>; /* gpio7_12 active low */
282 wakeup-gpios = <&gpio7 12 0>;
285 videoin: adv7180@20 {
286 compatible = "adi,adv7180";
294 crtcs = <&ipu1 0>, <&ipu1 1>;
299 reset-gpio = <&gpio1 29 0>;
304 fsl,mode = "i2s-slave";
309 pinctrl-names = "default";
310 pinctrl-0 = <&pinctrl_uart1_2>;
315 pinctrl-names = "default";
316 pinctrl-0 = <&pinctrl_uart2_3>;
321 pinctrl-names = "default";
322 pinctrl-0 = <&pinctrl_uart5_1>;
327 vbus-supply = <®_usb_otg_vbus>;
328 pinctrl-names = "default";
329 pinctrl-0 = <&pinctrl_usbotg_1>;
330 disable-over-current;
339 pinctrl-names = "default";
340 pinctrl-0 = <&pinctrl_usdhc3_2>;
341 cd-gpios = <&gpio7 0 0>;
342 vmmc-supply = <®_3p3v>;