Update network.lua

Fix display of WAN status when WAN is provided by using WWAN device or similar with other similar similar methods.
Explanation:
Before this, protocol was fetched from /etc/config/network for interface which often is wan_4 - but protocol is configured in file as wan, and therefore protocol is always none, since configuration is made for wan and then setup as wan_4 and possibly wan_6 if ipv6 is being used. This commit uses ubus to get used active protocol. For example, in case of qmi, it displays protocol as dhcp since even if I configured wan to use qmi, dhcp was used as a protocol for getting IP address.

diff --git a/modules/luci-base/luasrc/model/network.lua b/modules/luci-base/luasrc/model/network.lua
index 81fc416..741daa4 100644 (file)
--- a/modules/luci-base/luasrc/model/network.lua
+++ b/modules/luci-base/luasrc/model/network.lua
@@ -666,8 +666,8 @@ function get_status_by_address(self, addr)
 end
 
 function get_wannet(self)
-       local net = self:get_status_by_route("0.0.0.0", 0)
-       return net and network(net)
+       local net, stat = self:get_status_by_route("0.0.0.0", 0)
+       return net and network(net, stat.proto)
 end
 
 function get_wandev(self)
@@ -676,8 +676,8 @@ function get_wandev(self)
 end
 
 function get_wan6net(self)
-       local net = self:get_status_by_route("::", 0)
-       return net and network(net)
+       local net, stat = self:get_status_by_route("::", 0)
+       return net and network(net, stat.proto)
 end
 
 function get_wan6dev(self)