msgid "-- match by label --"
msgstr ""
+msgid "-- match by uuid --"
+msgstr ""
+
msgid "1 Minute Load:"
msgstr "1 분 부하:"
msgid "15 Minute Load:"
msgstr "15 분 부하:"
+msgid "4-character hexadecimal ID"
+msgstr ""
+
msgid "464XLAT (CLAT)"
msgstr ""
msgid "5 Minute Load:"
msgstr "5 분 부하:"
+msgid "6-octet identifier as a hex string - no colons"
+msgstr ""
+
+msgid "802.11r Fast Transition"
+msgstr ""
+
+msgid "802.11w Association SA Query maximum timeout"
+msgstr ""
+
+msgid "802.11w Association SA Query retry timeout"
+msgstr ""
+
+msgid "802.11w Management Frame Protection"
+msgstr ""
+
+msgid "802.11w maximum timeout"
+msgstr ""
+
+msgid "802.11w retry timeout"
+msgstr ""
+
msgid "<abbr title=\"Basic Service Set Identifier\">BSSID</abbr>"
msgstr ""
msgid "APN"
msgstr ""
-msgid "AR Support"
-msgstr ""
-
msgid "ARP retry threshold"
msgstr ""
msgid "Always announce default router"
msgstr ""
-msgid "An additional network will be created if you leave this checked."
-msgstr ""
-
msgid "Annex"
msgstr ""
msgid "Associated Stations"
msgstr "연결된 station 들"
-msgid "Atheros 802.11%s Wireless Controller"
-msgstr ""
-
msgid "Auth Group"
msgstr ""
msgid "Authentication"
msgstr ""
+msgid "Authentication Type"
+msgstr ""
+
msgid "Authoritative"
msgstr ""
msgid "Back to scan results"
msgstr ""
-msgid "Background Scan"
-msgstr ""
-
msgid "Backup / Flash Firmware"
msgstr "Firmware 백업 / Flash"
msgid "Check fileystems before mount"
msgstr ""
+msgid "Check this option to delete the existing networks from this radio."
+msgstr ""
+
msgid "Checksum"
msgstr ""
msgid "Common Configuration"
msgstr "공통 설정"
-msgid "Compression"
-msgstr ""
-
msgid "Configuration"
msgstr "설정"
msgid "Disable Encryption"
msgstr ""
-msgid "Disable HW-Beacon timer"
+msgid "Disabled"
msgstr ""
-msgid "Disabled"
+msgid "Disabled (default)"
msgstr ""
msgid "Discard upstream RFC1918 responses"
msgid "Do not forward reverse lookups for local networks"
msgstr ""
-msgid "Do not send probe responses"
-msgstr ""
-
msgid "Domain required"
msgstr ""
msgid "Dynamic <abbr title=\"Dynamic Host Configuration Protocol\">DHCP</abbr>"
msgstr ""
-""
msgid "Dynamic tunnel"
msgstr ""
msgid "Enable HE.net dynamic endpoint update"
msgstr ""
+msgid "Enable IPv6 negotiation"
+msgstr ""
+
msgid "Enable IPv6 negotiation on the PPP link"
msgstr ""
msgid "Enabled"
msgstr "활성화됨"
+msgid ""
+"Enables fast roaming among access points that belong to the same Mobility "
+"Domain"
+msgstr ""
+
msgid "Enables the Spanning Tree Protocol on this bridge"
msgstr "이 bridge 에 Spanning Tree Protocol 활성화합니다"
msgid "External"
msgstr ""
+msgid "External R0 Key Holder List"
+msgstr ""
+
+msgid "External R1 Key Holder List"
+msgstr ""
+
msgid "External system log server"
msgstr "외부 system log 서버"
msgid "Extra SSH command options"
msgstr ""
-msgid "Fast Frames"
-msgstr ""
-
msgid "File"
msgstr ""
msgid "Firewall"
msgstr "방화벽"
+msgid "Firewall Mark"
+msgstr ""
+
msgid "Firewall Settings"
msgstr "방화벽 설정"
msgid "Force TKIP and CCMP (AES)"
msgstr ""
+msgid "Force link"
+msgstr ""
+
msgid "Force use of NAT-T"
msgstr ""
msgid "IKE DH Group"
msgstr ""
+msgid "IP Addresses"
+msgstr ""
+
msgid "IP address"
msgstr "IP 주소"
msgid "IPv6-Address"
msgstr "IPv6-주소"
+msgid "IPv6-PD"
+msgstr ""
+
msgid "IPv6-in-IPv4 (RFC4213)"
msgstr ""
msgid "Invalid username and/or password! Please try again."
msgstr ""
-#, fuzzy
msgid ""
"It appears that you are trying to flash an image that does not fit into the "
"flash memory, please verify the image file!"
msgstr ""
-msgid "Java Script required!"
+msgid "JavaScript required!"
msgstr ""
msgid "Join Network"
"requests to"
msgstr ""
+msgid ""
+"List of R0KHs in the same Mobility Domain. <br />Format: MAC-address,NAS-"
+"Identifier,128-bit key as hex string. <br />This list is used to map R0KH-ID "
+"(NAS Identifier) to a destination MAC address when requesting PMK-R1 key "
+"from the R0KH that the STA used during the Initial Mobility Domain "
+"Association."
+msgstr ""
+
+msgid ""
+"List of R1KHs in the same Mobility Domain. <br />Format: MAC-address,R1KH-ID "
+"as 6 octets with colons,128-bit key as hex string. <br />This list is used "
+"to map R1KH-ID to a destination MAC address when sending PMK-R1 key from the "
+"R0KH. This is also the list of authorized R1KHs in the MD that can request "
+"PMK-R1 keys."
+msgstr ""
+
msgid "List of SSH key files for auth"
msgstr ""
msgid "Max. Attainable Data Rate (ATTNDR)"
msgstr ""
-msgid "Maximum Rate"
-msgstr ""
-
msgid "Maximum allowed number of active DHCP leases"
msgstr "Active DHCP lease 건의 최대 허용 숫자"
msgid "Metric"
msgstr ""
-msgid "Minimum Rate"
-msgstr ""
-
msgid "Minimum hold time"
msgstr ""
msgid "Missing protocol extension for proto %q"
msgstr ""
+msgid "Mobility Domain"
+msgstr ""
+
msgid "Mode"
msgstr ""
msgid "Move up"
msgstr ""
-msgid "Multicast Rate"
-msgstr ""
-
msgid "Multicast address"
msgstr ""
msgid "Option removed"
msgstr "삭제된 option"
+msgid "Optional"
+msgstr ""
+
msgid "Optional, specify to override default server (tic.sixxs.net)"
msgstr ""
msgstr ""
msgid ""
-"Optional. Adds in an additional layer of symmetric-key cryptography for post-"
-"quantum resistance."
+"Optional. 32-bit mark for outgoing encrypted packets. Enter value in hex, "
+"starting with <code>0x</code>."
+msgstr ""
+
+msgid ""
+"Optional. Base64-encoded preshared key. Adds in an additional layer of "
+"symmetric-key cryptography for post-quantum resistance."
msgstr ""
msgid "Optional. Create routes for Allowed IPs for this peer."
msgid "Outbound:"
msgstr ""
-msgid "Outdoor Channels"
-msgstr ""
-
msgid "Output Interface"
msgstr ""
msgid "PIN"
msgstr ""
+msgid "PMK R1 Push"
+msgstr ""
+
msgid "PPP"
msgstr ""
msgid "Pre-emtive CRC errors (CRCP_P)"
msgstr ""
+msgid "Prefix Delegated"
+msgstr ""
+
msgid "Preshared Key"
msgstr ""
msgid "Public prefix routed to this device for distribution to clients."
msgstr ""
+msgid "QMI Cellular"
+msgstr ""
+
msgid "Quality"
msgstr ""
+msgid "R0 Key Lifetime"
+msgstr ""
+
+msgid "R1 Key Holder"
+msgstr ""
+
msgid "RFC3947 NAT-T mode"
msgstr ""
msgid "Realtime Wireless"
msgstr ""
+msgid "Reassociation Deadline"
+msgstr ""
+
msgid "Rebind protection"
msgstr ""
msgid "Receiver Antenna"
msgstr ""
+msgid "Recommended. IP addresses of the WireGuard interface."
+msgstr ""
+
msgid "Reconnect this interface"
msgstr "이 인터페이스를 재연결합니다"
msgid "References"
msgstr ""
-msgid "Regulatory Domain"
-msgstr ""
-
msgid "Relay"
msgstr ""
msgid "Require TLS"
msgstr ""
+msgid "Required"
+msgstr ""
+
msgid "Required for certain ISPs, e.g. Charter with DOCSIS 3"
msgstr "특정 ISP 들에 요구됨. 예: Charter (DOCSIS 3 기반)"
msgid "Required. Base64-encoded private key for this interface."
msgstr ""
+msgid "Required. Base64-encoded public key of peer."
+msgstr ""
+
msgid ""
"Required. IP addresses and prefixes that this peer is allowed to use inside "
"the tunnel. Usually the peer's tunnel IP addresses and the networks the peer "
"routes through the tunnel."
msgstr ""
-msgid "Required. Public key of peer."
+msgid ""
+"Requires the 'full' version of wpad/hostapd and support from the wifi driver "
+"<br />(as of Feb 2017: ath9k and ath10k, in LEDE also mwlwifi and mt76)"
msgstr ""
msgid ""
msgid "Separate Clients"
msgstr ""
-msgid "Separate WDS"
-msgstr ""
-
msgid "Server Settings"
msgstr "서버 설정"
msgid "Services"
msgstr "서비스"
+msgid ""
+"Set interface properties regardless of the link carrier (If set, carrier "
+"sense events do not invoke hotplug handlers)."
+msgstr ""
+
msgid "Set up Time Synchronization"
msgstr ""
msgid "Static Routes"
msgstr "Static Route 경로"
-msgid "Static WDS"
-msgstr ""
-
msgid "Static address"
msgstr ""
"when finished."
msgstr ""
-#, fuzzy
msgid ""
"The system is flashing now.<br /> DO NOT POWER OFF THE DEVICE!<br /> Wait a "
"few minutes before you try to reconnect. It might be necessary to renew the "
"There is no password set on this router. Please configure a root password to "
"protect the web interface and enable SSH."
msgstr ""
-"이 공유기에 암호 설정이 되지 않았습니다. 웹 UI 와 SSH 부분을 보호하기 "
-"위해서 꼭 root 암호를 설정해 주세요."
+"이 공유기에 암호 설정이 되지 않았습니다. 웹 UI 와 SSH 부분을 보호하기 위해서 "
+"꼭 root 암호를 설정해 주세요."
msgid "This IPv4 address of the relay"
msgstr ""
msgid "Tunnel type"
msgstr ""
-msgid "Turbo Mode"
-msgstr ""
-
msgid "Tx-Power"
msgstr ""
msgid "USB Device"
msgstr ""
+msgid "USB Ports"
+msgstr ""
+
msgid "UUID"
msgstr ""
msgid "Used Key Slot"
msgstr ""
+msgid ""
+"Used for two different purposes: RADIUS NAS ID and 802.11r R0KH-ID. Not "
+"needed with normal WPA(2)-PSK."
+msgstr ""
+
msgid "User certificate (PEM encoded)"
msgstr ""
msgid "Write system log to file"
msgstr "System log 출력 파일 경로"
-msgid "XR Support"
-msgstr ""
-
msgid ""
"You can enable or disable installed init scripts here. Changes will applied "
"after a device reboot.<br /><strong>Warning: If you disable essential init "
"다!</strong>"
msgid ""
-"You must enable Java Script in your browser or LuCI will not work properly."
+"You must enable JavaScript in your browser or LuCI will not work properly."
msgstr ""
msgid ""
msgid "minimum 1280, maximum 1480"
msgstr ""
+msgid "minutes"
+msgstr ""
+
msgid "navigation Navigation"
msgstr ""
msgid "tagged"
msgstr ""
+msgid "time units (TUs / 1.024 ms) [1000-65535]"
+msgstr ""
+
msgid "unknown"
msgstr ""
msgid "« Back"
msgstr ""
-
-#~ msgid "An additional network will be created if you leave this unchecked."
-#~ msgstr ""
-
-#~ msgid "CPU"
-#~ msgstr ""
projects / project / luci.git / blobdiff