According to the info from NVRAM we should use port 8 for the CPU (and
interface eth2). Unfortunately it doesn't work right now, so lets switch
to the port 5.
Signed-off-by: Rafał Miłecki <zajec5@gmail.com>
git-svn-id: svn://svn.openwrt.org/openwrt/branches/chaos_calmer@46586
3c298f89-4303-0410-b956-
a3cf2f4a3e73
;;
esac
+# Workaround for devices using eth2
+case "$board" in
+netgear,r8000)
+ ifname=eth0
+ ;;
+esac
+
ucidef_set_interface_loopback
ucidef_set_interfaces_lan_wan "$ifname.1" "$ifname.2"
ucidef_add_switch "switch0" "1" "1"
+# Workaround for devices using CPU port 8 (connected to eth2)
+case "$board" in
+netgear,r8000)
+ ucidef_add_switch_vlan "switch0" "1" "0 1 2 3 5t"
+ ucidef_add_switch_vlan "switch0" "2" "4 5t"
+ board_config_flush
+ exit 0
+ ;;
+esac
+
# NVRAM entries may contain unsorted ports, e.g. Netgear R6250 uses
# vlan1ports=3 2 1 0 5*
# vlan2ports=4 5u
#include "b53_regs.h"
#include "b53_priv.h"
-@@ -1313,6 +1314,11 @@ static int b53_switch_init(struct b53_de
+@@ -1313,6 +1314,18 @@ static int b53_switch_init(struct b53_de
sw_dev->cpu_port = 5;
}
+ else if (of_machine_is_compatible("netgear,r8000"))
+ sw_dev->cpu_port = 8;
+
++ /*
++ * Workaround for devices using port 8 (connected to the 3rd iface).
++ * For some reason it doesn't work (no packets on eth2).
++ */
++ if (of_machine_is_compatible("netgear,r8000"))
++ sw_dev->cpu_port = 5;
++
/* cpu port is always last */
sw_dev->ports = sw_dev->cpu_port + 1;
dev->enabled_ports |= BIT(sw_dev->cpu_port);